L293D motor drive dual shield for arduino

5,00  με ΦΠΑ

Άμεσα Διαθέσιμο. Παράδοση 1-3 Εργάσιμες

Κατηγορίες ,

ΑΜΕΣΗ ΑΠΟΣΤΟΛΗ

Αυθυμερόν αποστολή για διαθέσιμα προϊόντα

ΜΕ ΚΑΡΤΑ

Πληρωμή με χρεωστική ή πιστωτική κάρτα

ΜΕΤΑΦΟΡΑ

Πληρωμή με τραπεζική μεταφορά

L293D Motor Control Drive Shield dual For arduino Mega2560 4 Channel L293 Motor Drive Expansion Board Motor Driver Module
Features :
L293D is a monolithic integrated, high voltage, high current, 4-channel driver.Basically this means using this chip you can use DC motors and power supplies of up to 36 Volts, thats some pretty big motors and the chip can supply a maximum current of 600mA per channel, the L293D chip is also what’s known as a type of H-Bridge. The H-Bridge is typically an electrical circuit that enables a voltage to be applied across a load in either direction to an output, e.g. motor.
– 2 interface for 5V Servo connected to the  high-resolution dedicated timer – no jitter!- Can drive 4 DC motors or 2 stepper motors or 2 Servo

– Up to 4 bi-directional DC motors with individual 8-bit speed selection

– Up to 2 stepper motors (unipolar or bipolar) with single coil, double coil or interleaved stepping.

– 4 H-Bridges: per bridge provides 0.6A (1.2A peak current) with thermal protection, can run motors on 4.5V to 36V DC

– Pull down resistors keep motors disabled during power-up
– reset button

– 2 external terminal power interface, for seperate logic/motor supplies

– Tested compatible For  Mega, Diecimila & Duemilanove